Step 1 CHARGE THE ROBOTIC BALL FOR 3-5 HOURS

Before initial use, charge the ball. Insert the plug of the AC Battery Charger into the Charger Port jack of the Robotic Ball. (See Figure A) Plug the AC Battery Charger into a voltage tape AC Outlet ONLY. (See Figure B) The ball will fully charge in about 3-5 hours. Recharge the unit only when it is completely discharged. 

 Step 2 - ATTACH ONE ELECTROSTATIC PAD 

Attach one disposable electrostatic pad to the underside of the Cleaning Frame and secure by pushing the pad down onto the black velcro tabs around the perimeter of the Cleaning Frame.

 Step 3 - PLACE THE CLEANING FRAME IN THE CENTER OF THE ROOM 

Clear the room. Place the Cleaning Frame in the center of the room. (See Figure D) For preparation hints for clearing the room, see page 6 of this operator’s manual for our “For Optimal Cleaning Performance” tips.

 Step 4 - SELECT CLEANING TIME

Press the Green ON/TIME button located on your RoboMop under the LCD screen on the left. (See Figure E) The LCD display screen will show the amount of time the RoboMop will clean your floor. To choose 1 hour and 30 minutes, press the ON/TIME button once. To choose 1 hour, press the ON/TIME button twice. To choose 30 minutes, press the ON/TIME button three times. Once you have chosen the time, the ON/TIME button on the LCD screen will flash 6X before turning on automatically, allowing you sufficient time to place the ball in the Cleaning Frame.

 Step 5 - INSERT THE ROBOTIC BALL IN THE CLEANING FRAME

Place the RoboMop ball into the center of the Cleaning Frame. Within 6 seconds, the RoboMop will turn itself on automatically.

Step 5 - INSERT THE ROBOTIC BALL IN THE CLEANING FRAME

Place the RoboMop ball into the center of the Cleaning Frame. Within 6 seconds, the RoboMop will turn itself on automatically.

 Step 7 - DISPOSAL OF PADS

Dispose soiled pads in the trash. (See Figure H) Do not dispose soiled pads in the toilet.